NXP T2080 PCIe Board

The EPT2080E PCIe board is a cost-effective and powerful platform for developing high performance networked control platforms. The board will fit into standard PCIe slots or run standalone, while 1 Gigabit Ethernet, 1 serial port (via USB) and 1 USB port provide the necessary I/O.

At the heart of the EPT2080E is the NXP QorIQ T2080. The T2080 is a highly integrated SoC that includes up to 4 e6500 cores at speeds up to 1.8GHz, a floating point unit, flash controller, DDR3L RAM controller, USB 2.0 host and device controllers. The high level of integration increases performance, while lowering system power consumption and cost.

Target Applications:

  • Single Board Computer
  • Ethernet Switch
  • Machine Vision and Camera
  • Industrial Robotics

The EPT2080E PCIe board is a cost-effective and powerful platform for developing high performance networked control platforms. The board will fit into standard PCIe slots or run standalone, while 2 10Gigabit Ethernet ports via SFP+ cages, 1 Gigabit Ethernet, 1 serial port (via USB) and 1 USB port provide the necessary I/O.

At the heart of the EPT2080E is the NXP QorIQ T2080. The T2080 is a highly integrated SoC that includes up to 4 e6500 cores at speeds up to 1.8GHz, a floating point unit, flash controller, DDR3L RAM controller, USB 2.0 host and device controllers, and multiple 10Gigabit Ethernet MACs. The high level of integration increases performance, while lowering system power consumption and cost.

The board is supported by the U-Boot bootloader and BSPs for Linux, VxWorks, and Green Hills INTEGRITY

Request A Quote

Features

Runs as a standalone development board!

  • Runs as a standalone development board!
  • Processor: NXP QorIQ T2080 running at up to 1.8GHz
  • RAM: Up to 1GB DDR3,  x32 bit DDR3L memory at 1066MHz
  • FLASH: Local boot memory x16 bit NOR FLASH or Micro-SD card
  • Card Edge / Bracket:
    • One Gigabit Ethernet via RJ45 connectors
    • USB master/slave interface via USB micro-B connector
    • Serial port via micro-B USB connector
  • Clocks: On board clocks for system, SerDes, and Ethernet
  • I2C Devices: EEPROM, temperature sensor, RTC and 1×2 header
  • Form Factor: PCI Express standard height, full mechanical length
  • Debug: On board JTAG / COP debug connector
  • SerDes:
    • SerDes 1 configured as x4 PCIe to a PCIe cable connector
    • SerDes 2 configured as either x8 PCIe 2.0 or x4 PCIe 3.0
  • Software: U-Boot Bootloader, Linux, VxWorks, and Green Hills INTEGRITY BSPs available

Request A Quote For This Product!

  • This field is for validation purposes and should be left unchanged.
Page Reader Press Enter to Read Page Content Out LoudPress Enter to Pause or Restart Reading Page Content Out LoudPress Enter to Stop Reading Page Content Out LoudScreen Reader Support